You will need the screw-driver with a crosswise edge.

1. Take a decorative slip.	2. Turn out the fastening screw...

Note The screw of fastening of an upholstery at the same time attached also a hand-rail in an armrest.

3.... take a hand-rail...	4.... wring out clamps...

5.... disconnect a block of wires from the control unit of a back window regulator and remove a hand-rail.	6. Turn out the button of shutdown of the lock of a door...

7.... also remove it.	8. Remove a frame of the internal handle of a back door.

9. Turn out two lower screws of fastening of an upholstery.	10. Hook edge of an upholstery...

11.... and, overcoming the elastic resistance of holders, remove an upholstery of a back door.

Note The upholstery of a back door (view from a reverse side) is attached to the door panel by four plastic holders. The damaged holders replace new, having taken out them from arms.

12. Turn out two screws of fastening and remove an arm.	13. Remove the internal handle of a back door (see. "Replacement of the internal handle of the drive of the lock of a back door").

14. For receiving access to fittings knots in a door unstick a polyethylene moisture protective film from the door panel.

15. Establish an upholstery of a back door and all removed details upside-down.