11.3. Removal and installation of facing of a radiator

It will be required to you: a key "on 10", the screw-driver with a flat edge.
1. Turn out four bolts of fastening of facing to the forward panel.
2. Hook the screw-driver the left lower part of decorative facing of a radiator and bring clamps out of holders on a bumper, similarly disconnect clamps on the right side.

Good advice
In order to avoid damage of a paint and varnish covering wind a screw-driver edge with an insulating tape and enclose under it a piece of rags or rubber.

3. Remove facing of a radiator.
4. Establish facing upside-down.