11.14.3. Removal and installation of a safety cushion of the forward passenger
It will be required to you: keys of TORX T40 and T30.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
Preventions
The attempt of removal of the module of a safety cushion without shutdown of the rechargeable battery can lead to operation of a pillow.
It is possible to start the following operations on removal of a safety cushion only after the full category of the condenser of the activator. For the category of the condenser it is necessary to wait not less than 15 min. after a wire detachment from the minus plug of the rechargeable battery.
Dismantling of the module of a safety cushion is forbidden.
Falling of the module of a safety cushion and hit on it of water, lubricant or oil is not allowed.
Impact on the module of a safety cushion of temperature above 95 °C is not allowed.
|
2. Remove a ware box (see. "Removal, dismantling and installation of the dashboard").
|
3. Shift a clamp...
|
4.... also separate a block of a plait of wires of the module of a safety cushion.
|
|
5. From the inside of the dashboard turn out two screws of fastening of the module of a safety cushion to a guard of a front and four screws of fastening to the dashboard.
|
6. Remove the module of a safety cushion of the forward passenger.
|
7. Install the safety cushion module as it should be, the return to removal.