It will be required to you: keys "on 8", "on 10", the screw-driver with a crosswise edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Remove a steering wheel (see. "Removal and installation of a steering wheel").

3. Remove casings of a steering column (see. "Removal and installation of casings of a steering column").

4. Remove a combination of devices (see. "Removal and installation of a combination of devices").

5. Turn out screws of fastening of the shelf for small things located under a steering column...

Note Screws of fastening of the shelf are so located.

6.... also remove the shelf.	7. Turn out two screws of fastening of the assembly block to a dashboard framework.

8. Turn out a bolt of fastening of a framework to a heater arm.	9. Turn out two screws of fastening of the internal panel to a dashboard framework.

10. Remove two decorative caps located on the left side of the dashboard...	11.... also turn out two bolts of side fastening of the dashboard to a body arm.

12. Similarly turn out two bolts on the right side of fastening of the dashboard.

13. Hook the screw-driver and remove edge of the right deflector of a nozzle of the central air supply...	14.... also take it.

15. Similarly take the left deflector of a nozzle of the central air supply.	16. Turn out two screws of the top fastening of an overlay of the central console.

17. Take the radio tape recorder from the central console of the dashboard and disconnect from it blocks of plaits of wires and the plug of the antenna.	18. Hook the screw-driver and remove a coaster frame.

19. Turn out four screws of fastening of a coaster...	20.... also take it from the dashboard.

21. Turn out two screws of average fastening of an overlay of the central console.

22. Disconnect blocks of wires from conclusions of switches.

23. Turn out two screws of fastening of a forward part of facing of a tunnel of a floor to the console of the dashboard and remove facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").	24. Having hooked the screw-driver an overlay of the control unit of system of heating (conditioning) and ventilation of salon...

25.... remove a slip.	26. Turn out four screws of fastening of the control unit of system of heating (conditioning) and ventilation of salon to the panel and two screws of the lower fastening of an overlay of the central console...

27.... also remove an overlay of the central console.	28. Turn out two screws of the lower fastening of a ware box.

29. Open a ware box and turn out four screws of the top fastening of a frame to the dashboard.	30. Squeeze two clamps located on each side a lamp of illumination of a ware box...

31.... take a lamp from a frame, disconnect a block of a plait of wires from a lamp conclusion and remove a ware box.	32. Remove a safety cushion of the forward passenger (see. "Removal and installation of a safety cushion of the forward passenger").

33. Turn out a bolt of fastening of a framework of the dashboard to a heater arm.	34. Under a frame of a windshield turn off two nuts of fastening of the dashboard to a front board...

35.... also remove the dashboard.	36. Turn out six screws of fastening of an air duct to a dashboard framework...

Note Screws of fastening of an air duct are so located to a dashboard framework.

37.... also remove an air duct.	38. Hook the screw-driver and remove one edge of the deflector of a nozzle of side air supply on the left side of the dashboard...

39.... also take it.	40. Turn out the fastening screw...

41.... wring out two clamps...	42.... also take an air supply nozzle on the left side of the dashboard.

43. Similarly remove a nozzle on the right side.

44. Install the dashboard and all removed details as it should be, the return to removal.