If the butterfly valve not completely opens (the engine does not give full capacity) or is closed (idling turns are unstable), at first try to adjust a cable of the drive of a butterfly valve. If adjustment of the drive of a butterfly valve it is impossible to achieve full opening or closing of a butterfly valve or the drive jams, replace a drive cable.

It will be required to you: a key "on 10", passatizh.

1. For visual control of movement of a butterfly valve weaken a collar of fastening and disconnect the airbringing sleeve from a branch pipe of throttle knot (see. "Removal and installation of the air filter").

2. At completely pressed accelerator pedal (it the assistant has to make) check the provision of a butterfly valve — it has to be completely open, and at the released accelerator pedal — is completely closed. Otherwise the drive needs to be adjusted.	3. Remove a spring bracket from a cable tip...

4.... and movement of a tip in an arm opening achieve forward that the butterfly valve was completely closed. At not completely opening gate movement of a tip achieve back that the gate completely opened. Record a cable tip in new situation, having inserted a bracket into its corresponding flute.	5. For replacement of a cable of the drive of a butterfly valve take out its tip from a groove of the sector and disconnect a cable from throttle knot.

6. Bring a cable cover tip out of an opening of an arm of throttle knot.	7. Turn out a bolt of fastening of an arm of a cable of the drive of a butterfly valve to the inlet pipeline.

8. In salon under the dashboard take a cable tip together with the plug from an accelerator pedal opening.	9. Remove the plug from a cable tip.

10. Extend a cable in podkapotny space through an opening in a front board.

11. Establish a cable as it should be, the return to removal.

12. After installation adjust a cable tension (see subitem 1-4).