The rotary fist is removed for its replacement in case of damage or for replacement of the hug bearing.

It will be required to you: keys "on 17", "on 18", "on 19", a face head "on 30", a key hexagon "on 5".

1. Lift and establish a forward part of the car on support. Remove a wheel.

2. Weaken a nave nut inhaling.

Note The nut of a nave is tightened by the big moment. Before its otvorachivaniye record a nave, having included the I transfer, and ask the assistant to press a pedal of a brake and to hold it until weakening of an inhaling of a nut.

3. Disconnect a block of a plait of wires from the sensor of frequency of rotation of a wheel, having squeezed a clamp of its fastening.

Note If you remove a rotary fist for replacement... ... turn out a bolt of fastening of the sensor... ... also take it from a fist opening.

4. Vypressuyte from the lever of a rotary fist a finger of the hinge of an external tip of steering draft (see. "Replacement of an external tip of steering draft").	5. Turn out two bolts of fastening of a guide of blocks of a support of the brake mechanism to a rotary fist...

6.... remove a support from a fist, without disconnecting from it a hose...	7.... also tie up, for example, to a spring of a forward suspension bracket, without allowing a tension or excesses of a hose.

8. Disconnect a finger of a spherical support of a forward suspension bracket from a lug of a rotary fist (see. "Replacement of a spherical support").

9. Finally turn off a nave nut...	10.... also remove the washer established under it.

11. Separate a rotary fist and a damping rack (see. "Removal and installation of a damping rack").

12. Remove a rotary fist assembled with a nave of a forward wheel and a brake disk, having pulled out a shaft of the external CV JOINT of the drive of a forward wheel from a nave.

13. Establish details as it should be, the return to removal.

14. Check and if necessary adjust the angles of installation of wheels. Use services of the workshops having the special equipment.