It will be required to you: all tools necessary for removal of a cross-piece of a forward suspension bracket (see. "Removal and installation of a cross-piece of a forward suspension bracket"), keys "on 18", "on 19".

1. Slow down the car the parking brake and establish an antiretractable emphasis ("boots") under back wheels. Raise a jack a forward part of the car and establish it on support. Remove forward wheels.

Prevention Weaken and tighten bolts of fastening of wheels only on the car standing on the earth.

2. Remove a cross-piece of a forward suspension bracket (see. "Removal and installation of a cross-piece of a forward suspension bracket").

Note It is necessary to remove a cross-piece of a forward suspension bracket because it is impossible to remove brackets of fastening of a bar of the stabilizer to a cross-piece of a forward suspension bracket on the car because of too small gap between brackets and the basis of a body.

3. Turn out on one bolt of brackets of fastening of a bar of the stabilizer to a cross-piece and turn off on one nut of fastening of racks of the stabilizer to suspension bracket levers.	4. Remove the lower plates from stabilizer racks...

5.... and lower rubber pillows.

Note Replace strongly pressed out or hardened pillows.

6. Remove brackets of fastening of a bar of the stabilizer to a cross-piece...

Note Or with the damaged carving replace strongly corroded, deformed brackets.

7.... also remove the stabilizer.	8. Remove the top rubber pillows from racks...

9.... and top plates.	10. Remove from a rack bar...

Note If the carving of racks is damaged or their rubber plugs are strongly deformed and hardened, replace racks assembled.

11.... and rubber pillows of its fastening to a cross-piece of a forward suspension bracket.

Note Replace pillows if they are strongly deformed or hardened.

12. Establish details as it should be, the return to removal, tighten bolts and nuts the moment specified in the appendix 1.

Note After replacement of details of the stabilizer of cross stability check and if necessary adjust the angles of installation of wheels. Use services of the workshops having the special equipment.