It will be required to you: keys "on 13", "on 22" (two), a key for bolts of wheels, a stripper of spherical hinges.

Notes It is more convenient to perform work on the elevator. It is possible to execute it and on the car installed on support. Replacement of a tip is shown on the example of the left side draft, replace the right tip similarly. Carving of the left tip right, and right — left.

1. Lift and establish on a support a forward part of the car from the replaced tip. Remove a wheel.

Prevention Slow down the car the parking brake and establish an antiretractable emphasis ("boots") under back wheels.

Good advice If fasteners are strongly polluted, clear them a metal brush and process the easily getting lubricant, for example WD-40.

2. Measure and remember length of a free part of a carving of steering draft (the size and) that at assembly whenever possible not to break corners of a convergence of wheels.

Note It is for descriptive reasons shown on the removed steering draft.

3. Turn off a nut of fastening of a spherical finger of a tip to the lever of a rotary fist.

Note Nuts of fastening of spherical fingers of external tips of steering drafts самоконтрящиеся. At each removal replace nuts new.

4. Establish a stripper of spherical hinges...	5.... and a vypressuyta a finger from a lug of the rotary lever.

Good advice In the absence of a stripper the finger of the spherical hinge can be beaten out sharp blows of the hammer to an end face of a lug of the rotary lever, striking blows along a lever axis.

6. Weaken an inhaling of a lock-nut of a tip of steering draft.

Note For descriptive reasons this and further operations are shown on the removed steering draft.

7. Shift a tip of steering draft from the place, keeping draft from a provorachivaniye the second key...	8.... also screw together a tip from steering draft, counting quantity of turns that at installation of a new tip the convergence of wheels whenever possible did not change.

9. Establish a new tip as it should be, the return to removal, having screwed it on steering draft on such speed how many it was counted at removal, and tighten a lock-nut the moment of 98 N · m.

10. Repeatedly measure length of a free part of a carving of steering draft: it has to be equal measured in item 2. If it not so, weaken a lock-nut and either screw, or screw together a tip depending on that, length of a free part of a carving increased or decreased, tighten a lock-nut and repeat check.

11. Check and in case of need adjust the angles of installation of wheels at service station.