Fig. 6.6. The gear shifting drive (the inlet pipe is for descriptive reasons removed): 1 – hinge of draft of the coulisse of a control lever transmission; 2 – draft of the coulisse of the lever of gear shifting; 3 – gear shifting drive mechanism arm; 4 – gear shifting lever buffer; 5 – gear shifting lever; 6 – lever of the choice of transfers; 7 – draft of the choice of transfers; 8 – draft of gear shifting

At increase in gaps in the drive of gear shifting (fig. 6.6) there is a vibration of the lever of gear shifting during the movement, and also becomes indistinct and complicated gear shifting. In this case it is necessary to repair drive hinges.

It will be required to you: keys "on 10", "on 13", a stripper of lock rings (or kruglogubets), the screw-driver with a flat edge.

1. Unfasten the screw-driver a clamp of the hinge of draft of the choice of transfers...	2.... also disconnect the hinge from a spherical support of the intermediate lever of the choice of transfers.

3. Unclench the screw-driver a spring clamp of draft of gear shifting...	4.... take a clamp from an opening of draft and disconnect draft from the gear shifting lever.

5. Mark mutual position of draft of the coulisse of a control lever with the transmission and naves of the lever of the choice of transfers not to break adjustment of the drive at the return assembly.	6. Weaken an inhaling of a nut of a bolt of klemmovy connection of draft and the lever...

7.... also remove the lever of the choice of transfers from draft, at the same time bringing the gear shifting lever buffer out of its lead.	8. Turn out a forward bolt...

9.... and two back bolts of fastening of an arm of the mechanism of the drive of gear shifting...	10.... also remove an arm together with the gear shifting lever.

11. For repair of hinges of the lever of the choice of transfers unfasten the screw-driver a clamp of the hinge of draft of the choice of transfers...

12.... also remove the hinge from a spherical finger of the lever.

Note Draft of the choice of transfers is made assembled with hinges therefore at emergence of side plays in hinges replace draft assembled.

13. Wring out the screw-driver a spring clamp of an antisplash guard...	14.... also remove a guard from the lever.

15. Remove the rubber damping washer from a spherical finger of the lever.

Note Replace strongly pressed out or hardened damping washer.

16. Turn off a nut of a bolt of klemmovy connection, take a bolt from openings of a coupling collar...	17.... also remove a collar from a lever nave.

18. For repair of hinges of the lever of gear shifting press passatizham the direct end of a spring clamp of draft of gear shifting...

19.... take a clamp from a draft opening...	20.... also disconnect draft from the lever.

21. Turn off a nut of fastening of the lever to an axis...	22.... also remove the lever from an axis.

23. Unclench the ends of a spring clamp of an axis...	24.... remove a clamp...

25.... also take an axis from arm plugs.

Notes At damage or wear of the buffer of the lever replace its axis assembled with the buffer. At damage or wear by the transmission directing drafts of the coulisse of a control lever replace an arm assembled from a guide as connection of knot non-demountable.

26. Take plastic plugs of an axis of the lever of gear shifting from arm openings.

Note Replace strongly worn-out plugs.

27. Collect the drive of control of the transmission and install it on the car as it should be, the return to dismantling and removal. At connection of the lever of gear shifting with draft of the coulisse of a control lever the transmission combine the tags put before dismantling.