Replace cables of the drive of the parking brake at their excessive pulling (impossibility of adjustment of the parking brake), mechanical injuries of veins of cables or their covers.

Note Each brake mechanism of back wheels is given by a separate cable. Operations on removal and installation of cables are shown on the example of the left cable. The right cable is removed and established similarly.

It will be required to you: two keys "on 10", passatizh, the screw-driver with a flat edge.

1. Remove a back part of facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").	2. Weaken a lock-nut inhaling...

3.... and, holding cables from a provorachivaniye, turn off adjusting nuts.	4. Remove the brake drum (see. "Removal and installation of reels of brake mechanisms of back wheels").

5. Remove a back brake shoe (see. "Replacement of blocks of brake mechanisms of back wheels").

Note The tip of a cable of the drive of the parking brake can be disconnected, without removing a back brake shoe, but for convenience of installation we recommend it to remove.

6. Disconnect a cable tip from the razzhimny lever and remove a back brake shoe.	7. Bring a cable braid out of the holder in the body basis...

8.... and beams of a back suspension bracket.	9. Take one tip of a cable from an opening of a protective guard of the back brake mechanism...

10.... and the second — from an opening in the body basis...	11.... also remove a cable.

12. Establish a cable of the drive of the parking brake as it should be, the return to removal.

13. Adjust the parking brake system (see. "Adjustment of the drive of the parking brake").