For preliminary check of correctness of adjustment of the drive of the parking brake lift the drive lever up to an emphasis, at the same time you have to hear 3–5 clicks of the ratchet device. If the number of clicks does not keep within the specified interval or the car is not kept by the parking brake (see. "Check of the parking brake"), adjust the drive.

The adjusting knot of the drive of the parking brake is located in salon under facing of a tunnel of a floor.

It will be required to you: two keys "on 10", passatizh.

1. Check correctness of adjustment of gaps between brake shoes and drums of brake mechanisms of back wheels. For this purpose several times strongly press a brake pedal at the lever of the drive of the parking brake lowered against the stop down.

2. You will hang out a back part of the car and establish it on reliable support.

3. Remove a back part of facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").

Note The seat of the driver is removed for descriptive reasons. To get access to fastenings of facing and to adjusting knot of the drive of the parking brake, it is not required to remove a seat.

4. Lift the lever of the parking brake on four clicks.	5. Weaken an inhaling of lock-nuts...

6.... and, holding cables from a provorachivaniye, in turn wrap adjusting nuts until a full zatormazhivaniye of back wheels.

7. Tighten lock-nuts and establish a back part of facing of a tunnel of a floor.

8. Install the car on wheels.