It will be required to you: keys "on 10", "on 13", "on 22", a face head "on 16", the screw-driver with a flat edge.

1. Holding a key "on 10" bolts, turn off a key "on 13" two nuts of fastening of a flange of a reception pipe to a converter flange, separate flanges and remove sealing laying.	2. A face head "on 16" turn off three nuts of fastening of a flange of a reception pipe to a final collector.

Good advice Nuts of fastening of a flange of a reception pipe after long operation "burn" to hairpins. In order to avoid breakage of hairpins before an otvorachivaniye moisten threaded connections with WD-40 liquid (or structures, similar it) or kerosene. We recommend to replace at each dismantling of connections nuts new as sides of nuts can be crumpled and at the subsequent inhaling (otvorachivaniya) can break absolutely then it will be very difficult to turn off a nut.

3. Put forward a clamp from a block of the sensor of concentration of oxygen...	4.... also separate a block.

5. Remove from an arm of a reception pipe of a pillow of a suspension bracket (operation is shown at the removed converter of the fulfilled gases).	6. Shift a flange of a reception pipe from hairpins of a final collector and remove a pipe.

7. Remove sealing laying from a flange of a final collector.

Good advice Replace new sealing laying between flanges of a reception pipe, converter and a final collector at each dismantling of connection as strongly pressed out laying will not provide reliable consolidation.

8. A key "on 22" turn out the sensor of concentration of oxygen from a reception pipe and establish it on a new reception pipe.

9. Establish a reception pipe as it should be, the return to removal.