It will be required to you: a key "on 10", a pricker or the thin screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Turn off nuts of fastening of the block to an engine mudguard...	3.... also remove the block from hairpins.

4. Wring out clamps of the lower cover of the block...	5.... also uncover.

6. A pricker or the thin screw-driver with a flat edge wring out clamps of plugs of an electrical wiring, take plugs with wires from the assembly block and remove the assembly block from the car.

Good advice Mark plugs not to mix at installation of the new assembly block.

7. Install the block of the relay and safety locks of headlights and the conditioner as it should be, the return to removal.