Note The steering column can be removed assembled with the switch of ignition or without it (depending on the purpose of removal of a steering column). In this subsection removal of a steering column with removal of the switch of ignition is described.

It will be required to you: keys "on 10", "on 13", screw-drivers with flat and crosswise edges.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. In a motor compartment raise a protective cover of an intermediate shaft...	3.... also turn out a bolt of klemmovy connection of an intermediate shaft with shaft gear wheel of the steering mechanism.

4. In interior of the car remove a steering wheel (see. "Removal and installation of a steering wheel"), previously having established it in the situation corresponding to the rectilinear movement.

5. Remove a casing of a steering column (see. "Removal and installation of casings of a steering column").

6. Remove a contact ring of a safety cushion and the switch of a sound signal (see. "Replacement of understeering switches").	7. Remove understeering switches assembled with a connector (see. "Replacement of understeering switches").

8. Remove the switch (lock) of ignition (see. "Removal and installation of the switch (lock) of ignition").	9. Remove a combination of devices (see. "Removal and installation of a combination of devices").

10. Remove the dashboard (see. "Removal, dismantling and installation of the dashboard").	11. Turn out three screws of the top fastening of a noise isolation of a board of a front.

12. Hook the screw-driver...	13.... also take a percussion cap of the lower fastening of a noise isolation...

14.... also remove it.	15. Unbend a first line of a rug of a floor and turn off three nuts of fastening to a board of a front of the lower arm of a steering column...

16.... turn out two bolts lower...	17.... and top top arm of fastenings...

18.... also remove a steering column from the car, taking in salon through a sealant in a front board an intermediate shaft of steering.

19. Establish details as it should be, the return to removal.