It will be required to you: rubber pear, source of a direct current of 12 V.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Press a spring clamp of a block of a motor plait of wires and disconnect a block from the valve.

Note For descriptive reasons the throttle knot is removed.

3. Remove from an arm of the inlet pipeline and disconnect the bringing and taking away hoses from its unions.

Note So the electromagnetic valve of a purge of an adsorber removed from the car looks. Pay attention to its marking that when replacing to install the same valve.

4. For valve check attach a pear to the bringing valve union (it is used as the pump, and the depression supply hose to the valve can use as an adapter for accession of a pear). Press on a pear — in the valve pressure has to be created.	5. Then connect a source of a direct current of 12 V to valve conclusions — the valve has to open, and pressure has to disappear (the pear will contract without resistance). Otherwise replace the valve.

6. Install the adsorber purge valve as it should be, the return to removal.