The starter is established on a coupling case from the forward party of the power unit.

It will be required to you: keys "on 13", "on 16".

1. Wring out a clamp....	2.... also disconnect a block of the operating wire from the traction relay.

3. Remove a cap from a nut of fastening of a power wire.	4. A key "on 13" turn off a nut of fastening of a power wire...

5.... also remove a wire from a contact bolt of the traction relay.	6. A key "on 13" turn off a nut of fastening of a "mass" wire...

7.... also remove a wire from a hairpin.	8. A key "on 16" turn out two bolts and a key "on 13" turn off a nut of fastening of a starter...

9.... also remove a starter.

10. Establish a starter as it should be, the return to removal.