Prevention Before replacement of lamps in devices of lighting of the car disconnect a wire from the minus plug of the rechargeable battery.

For replacement of lamps of a block headlight execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

Notes Replacement of lamps of the left block headlight is shown. Lamps in the right block headlight are symmetrized, replace them similarly.

2. For convenience when replacing lamps in the left block headlight remove the rechargeable battery from the car (see. "Removal and installation of the rechargeable battery"), and when replacing lamps in the right block headlight – the air filter (see. "Removal and installation of the air filter").

3. Squeeze a spring clamp of a block of a plait of wires.	4.... also disconnect a block from the socket of the index of turn.

5. Turn a cartridge of a lamp of the index of turn counterclockwise...	6.... also take it from a block headlight.

7. Having pressed a lamp, turn it counterclockwise...	8.... also take from the boss.

9. Establish a new lamp in a cartridge, and a cartridge in a block headlight.

10. Remove a rubber cover of a lamp of driving beam of headlights.	11. Disconnect a block with wires from lamp conclusions.

12. Bring a spring clamp out of hooks on a reflector...	13.... cast away a clamp...

14.... also take a lamp of driving beam.

Prevention Do not touch by lamp flask fingers as the galogenovy lamp strongly heats up and fatty spots will cause darkening of a flask. Take a lamp for a flask only in pure gloves or a pure rag. If on a lamp after all there were fatty spots, remove them with alcohol.

15. Insert a new lamp into a reflector and record it the spring holder.

16. Take a cartridge of a lamp of dimensional light from an opening in a reflector.	17. Take a lamp from the boss.

18. Insert a new lamp into a cartridge and establish a cartridge into place.

19. Remove a rubber cover of a lamp of passing beam of headlights.	20. Disconnect a block with wires from lamp conclusions.

21. Bring a spring clamp out of hooks on a reflector...	22.... cast away a clamp...

23.... also take a lamp of passing beam.

24. Insert a new lamp into a reflector and record it the spring holder.

For replacement of a lamp of a fog light execute the following.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Install the car on the elevator or a viewing ditch.

3. Turn a cover of a fog light counterclockwise...	4.... also uncover.

5. Disconnect two blocks with wires from lamp conclusions.	6. Bring a spring clamp out of a hook on a reflector, cast away a clamp...

7.... also take a lamp of a fog light.

Prevention Do not touch by lamp flask fingers as the galogenovy lamp strongly heats up and fatty spots will cause darkening of a flask. Take a lamp for a flask only in pure gloves or a pure rag. If on a lamp after all there were fatty spots, remove them with alcohol.

8. Insert a new lamp into a reflector and record it the spring holder.

9. Establish a cover of a fog light and turn it clockwise against the stop.

For replacement of a lamp of a side lamp of the index of turn execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Take the side index of turn from an opening in a wing (see. "Replacement of the side index of turn").	3. Turn a cartridge of a lamp counterclockwise...

4.... also take it from the index case.	5. Take a lamp from the boss.

6. Insert a new lamp into a cartridge, and a cartridge in the index case.

7. Establish a side lamp of the index of turn as it should be, the return to removal.

For replacement of any lamp in a back lamp execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Open a back door.

3. Unbend a luggage carrier upholstery behind a back lamp.

Note Replacement of lamps of the index of turn, dimensional light and stoplight is for descriptive reasons shown on the removed lamp.

4. Turn a cartridge of a lamp of the index of turn counterclockwise...	5.... also take it from a lamp.

6. Press a lamp, turn it counterclockwise and take from the boss.

7. Establish a new lamp, having turned it clockwise before fixing in the boss.

Similarly replace a lamp of dimensional light and a stoplight (it is established in the red boss).

8. The screw-driver with a flat edge turn on 90 ° a lamp cover clamp...	9.... also cast away a cover.

10. Turn counterclockwise a cartridge of a lamp of light of a backing...	11.... also take a cartridge from a lamp.

12. Having pressed a lamp, turn it counterclockwise...	13.... also take from the boss.

14. Establish a new lamp, having turned it clockwise before fixing in the boss.

Similarly replace a lamp of fog light (it is established in the green boss).

For replacement of lamps in lamps of illumination of registration plate execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Turn out two screws of fastening...	3.... also take a lamp from an overlay of a door of a back.

4. Press a clamp of a block of a plait of wires...	5.... also disconnect a block from a lamp.

6. Take out a cartridge from the lamp case...	7.... also take a lamp of a lamp of illumination of registration plate from the boss.

8. Establish a new lamp in a cartridge.

9. Establish the removed details as it should be, the return to removal.

For replacement of lamps of an additional stoplight execute the following.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Squeeze two clamps...	3.... also disconnect a stoplight from the lens.

4. Take out the fused lamp from the boss and establish new.

5. Collect a stoplight upside-down.

For replacement of lighting lamps of salon execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Hook a plafond...	3.... and, overcoming resistance of clamps, remove a plafond of illumination of salon.

4. Turn counterclockwise a cartridge of a lamp of directional light...	5.... also take a cartridge with a lamp from a plafond.

6. Take a lamp from the boss, establish a new lamp and establish a cartridge in a plafond.

7. Wring out clamps of the lens...	8.... also remove the lens from a plafond.

9. Wring out spring contact and take a lamp.

10. Establish a lamp and a plafond as it should be, the return to removal.

For replacement of the lighting lamp of the luggage compartment execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Hook a plafond of lighting of the luggage compartment...	3.... also take it from a nest.

4. Wring out spring contact and take a lamp.

5. Establish a lamp as it should be, the return to removal.