9.6.1. Replacement of the vacuum amplifier of brakes

It will be required to you: a key "on 13", a face head "on 15", passatizh, the screw-driver with a flat edge.
1. Having hooked the screw-driver a tip of a vacuum hose, take it from the sealing plug of an opening in the case of the amplifier.
2. Remove the main brake cylinder (see. "Replacement of the main brake cylinder").

Good advice
With sufficient skills the main brake cylinder can be not removed completely, it is enough to disconnect of it from the amplifier of brakes and to take away forward, without disconnecting from it pipelines.

3. In salon under the dashboard, having hooked the screw-driver a clamp...
4.... remove a locking bracket...
5.... also take out a finger from an opening of a fork of a pusher and a pedal of a brake.
6. Turn off three nuts of fastening of the vacuum amplifier of brakes to a front board...
7.... also remove the vacuum amplifier of brakes.
8. Establish the vacuum amplifier and all removed details as it should be, the return to removal.
9. If completely removed the main brake cylinder, fill in brake fluid and remove air from system (see. "Pumping of a hydraulic actuator of the brake system").